12
SERVICE WORK ON THE CHASSIS
–
Position the fork legs.
Info
Grooves are milled into the side of the upper end of the fork legs. The sec-
ond milled groove (from the top) must be flush with the top edge of the
upper triple clamp.
Position bleeder screws
102269-10
–
Tighten screws
Guideline
Screw, bottom triple clamp
102270-10
–
Tighten screw
Guideline
Screw, top steering head
102271-10
–
Tighten screw
Guideline
Screw, top steering stem
102272-10
–
Tighten screws
Guideline
Screw, top triple clamp
102272-11
–
Position the brake caliper. Mount and tighten screws
Guideline
Screw, front brake caliper
–
Mount cable tie(s)
–
Position the brake line and wiring harness. Put on the clamp and mount and
tighten screws
102261-12
toward the front.
.
.
.
.
M8
.
.
M8
15 Nm
(11.1 lbf ft)
M20x1.5
12 Nm (8.9 lbf ft)
M8
20 Nm
(14.8 lbf ft)
M8
20 Nm
(14.8 lbf ft)
with the washers.
25 Nm
Loctite
(18.4 lbf ft)
58
®
243™