Gravely 1842 ZT Owner's/Operator's Manual page 17

CHECK BELTS
• Check belts for deterioration or wear and replace
if necessary. Replace belts to accommodate belt
stretch and wear in the traction drive or mower
drive. Refer to Service and Adjustments for
procedures.
CLEAN TRANSAXLE
• Keep transaxles free from buildup of dirt and
chaff which can restrict cooling.
LUBRICATION
• Apply Stens Hi-Temp Grease or equivalent to the
lube fittings on idler pivots.
• Grease the fittings on the front wheel spindles,
the idler arms, and the steering controls every 50
hours of operation.
Clutch Shaft
Idler
1740 with Serial Numbers Less
Than 1,000
CLEANING
• Clean engine, battery, seat, deck, etc. of all dirt
Front
• Remove packed grass and debris from under
Mower Drive
• Keep finished surfaces and wheels free of all
Idler
• Protect painted surfaces with automotive type
IMPORTANT: Never spray unit with water or store unit
outdoors. Water can seep into sealed bearings, which
are sealed against dirt and debris only, causing
reduced component life.
ENGINE
Transaxle Idler
To access engine:
1. Unhook Engine Cover latch.
2. Lift rear of cover and slide out. Set cover aside.
3. To replace cover: Slide front of cover into slot.
Back
OE0331
4. Insert the back edge of cover into its support
5. Hook Engine Cover latch securely.
Fuel Cap
OE0700
GB - 18
All Other Units
and debris with a brush or cloth. Do not use
solvents, harsh cleaners or abrasives.
mower deck.
gasoline, oil, etc.
wax. Lightly coat unpainted surfaces with spray
lubricant and wipe off excess with soft cloth.
bracket.
Engine Cover
OE0701
Engine
Cover
Latch
OE0800