Advertisement
Item Description
already listed as a separate item above)
Components and parts containing toner and ink,
including liquids, semi-liquids (gel/paste) and toner
Components and waste containing asbestos
Components, parts and materials containing
refractory ceramic fibers
Components, parts and materials containing
radioactive substances
2.0 Tools Required
List the type and size of the tools that would typically be used to disassemble the product to a point where components and
materials requiring selective treatment can be removed.
Tool Description
Screwdriver
Screwdriver
Screwdriver
3.0 Product Disassembly Process
3.1 List the basic steps that should typically be followed to remove components and materials requiring selective treatment
including the required steps to remove the external enclosure:
1. Remove Log Low
2.
Remove Battery pack
3.
Remove FAN & Thermal module
4.
Remove Motherboard
5.
Remove Speaker Rear & Cavity
6.
Remove Hinge for the Logic Up
7.
Remove Hinge Cap
8. Remove Both Hinge
9. Remove LCD Cover
10. Remove Antenna
11. Remove EDP cable / TS / Camera module / Sensor PCB
3.2 Optional Graphic. If the disassembly process is complex, insert a graphic illustration below to identify the items contained
in the product that require selective treatment (with descriptions and arrows identifying locations).
EL-MF877-00
Template Revision C
Last revalidation date 09-May-2018
Notes
Include the cartridges, print heads, tubes, vent
chambers, and service stations.
HPI instructions for this template are available at
EL-MF877-01
Quantity of
items
included in
product
Tool Size (if
applicable)
Philip #1
Philip #0
Philip #T5
Page 2
Advertisement
