Leds - ZyXEL Communications GS1300 Series User Manual

3.3 LEDs

After you connect the power to the Switch, view the LEDs to ensure proper functioning of the Switch
and as an aid in troubleshooting.
Table 7 LED Descriptions
LED
PWR
PoE MAX
Ethernet Ports and PoE
Link/ACT
Port 1 – 9
(GS1300-10HP)
Port 1 – 17
(GS1300-18HP)
Port 1 – 24
(GS1300-26HP)
PoE Mode
Port 1 – 8
(GS1300-10HP)
Port 1 – 16
(GS1300-18HP)
Port 1 – 24
(GS1300-26HP)
Uplink Interface
Ethernet Ports
Port 1 – 9
(GS1300-10HP)
Port 1 – 17
(GS1300-18HP)
Port 1 – 24
(GS1300-26HP)
SFP Slots
Port 10 (GS1300-
10HP)
Port 18 (GS1300-
18HP)
Port 25 – 26
(GS1300-26HP)
Chapter 3 Hardware Panels
COLOR STATUS
Green On
Off
Amber On
Off
Green Blinking
On
Amber Blinking
On
Off
Green On
Amber On
Off
Green Blinking
On
Amber Blinking
On
Off
Green On
Blinking
Amber On
Blinking
Off
GS1300 Series User's Guide
DESCRIPTION
The Switch is receiving power from the power supply.
The Switch is not receiving power from the power supply.
More than 95 percent of the power budget is being used. Less
than five percent of the power supplied budget remains. Five
percent is the default value.
Note: You should disconnect some PDs.
The Switch has a sufficient power supply for all connected PDs.
The Switch is transmitting/receiving to/from a 1000 Mbps
Ethernet network.
The link to a 1000 Mbps Ethernet network is up.
The Switch is transmitting/receiving to/from a 10 Mbps or a 100
Mbps Ethernet network.
The link to a 10 Mbps or a 100 Mbps Ethernet network is up.
The link to an Ethernet network is down.
Power supplied to all PoE Ethernet ports meets the IEEE 802.3at
standard.
Power supplied to all PoE Ethernet ports meets the IEEE 802.3af
standard.
There is no power supplied.
The Switch is transmitting/receiving to/from a 1000 Mbps
Ethernet network.
The link to a 1000 Mbps Ethernet network is up.
The Switch is transmitting/receiving to/from a 10 Mbps or a 100
Mbps Ethernet network.
The link to a 10 Mbps or a 100 Mbps Ethernet network is up.
The link to an Ethernet network is down.
The uplink port is linking at 1000 Mbps.
The Switch is transmitting/receiving data at 1000 Mbps.
The uplink port is linking at 100 Mbps.
The Switch is transmitting/receiving data at 100 Mbps.
There is no link or the uplink connection is down.
25