Bosch PROFESSIONAL GST 65 Operating Instructions Manual page 8

OBJ_BUCH-286-001.book Page 8 Tuesday, October 24, 2006 12:54 PM
Technical Data
Jigsaw
Article number
Stroke rate control
Rated power input
Output power
Stroke rate at no load n
0
Stroke
Cutting capacity, max.
– in wood
– in aluminum
– in non-alloy steel
Bevel cuts (left/right), max.
Weight according to EPTA-Procedure 01/2003
Protection class
The values given are valid for nominal voltages [U] of 230/240 V. For lower voltages and models for specific countries, these
values can vary.
Please observe the article number on the type plate of your power tool. The trade names of individual tools may vary.
Product Features
The numbering of the product features refers to the
illustration of the power tool on the graphics page.
1 Lock-on button for On/Off switch
2 On/Off switch
3 Base plate
4 Guide roller
5 Saw blade*
6 Contact protector
7 Screwdriver
8 Stroke rod
9 Splinter guard*
10 Screw(2x)
11 Scale for miter angle
12 Angle gauge**
13 Bolt hole
14 Positioning pin/mark
15 Lead for the parallel guide
16 Locking screw for parallel guide*
17 Parallel guide with circle cutter*
18 Centering tip of the parallel guide*
*The accessories illustrated or described are not
included as standard delivery.
**Commercially available (not included in the delivery
scope)
8 | English
GST 65
GST 65 B
PROFESSIONAL
3 601 E09 1..
–
W 400
W 230
spm 3100
mm 18
mm 65
mm 12
mm 3
° 45
kg 1.7
/ II
Assembly
Replacing/Inserting the Saw Blade
Before any work on the power tool itself, pull
the mains plug.
When mounting the saw blade, wear protective
gloves. Danger of injury when touching the saw blade.
Selecting a Saw Blade
An overview of recommended saw blades can be found
at the end of these instructions. Use only T-shank saw
blades. The saw blade should not be longer than
required for the intended cut.
Use a thin saw blade for narrow curve cuts.
Inserting the Saw Blade (see figure A)
• Loosen the screws 10 until the assembly plate with
the guide roller 4 can be moved toward the rear.
• Insert the screwdriver 7 from above into the stroke
rod 8 and turn approx. 3 – 4 turns in counterclock-
wise direction.
• Insert the saw blade 5 lateral to the cutting direction
into the stroke rod 8.
• Turn the saw blade 5 so that the toothing faces
toward the cutting direction. Pull the saw blade 5 a
little downward until it engages.
• Insert the screwdriver 7 from above into the stroke
rod 8 and turn in clockwise direction until the saw
blade 5 is locked.
• Push the assembly plate with the guide roller 4 for-
wards until it faces against the back of the saw
blade and tighten the screws 10 again.
Check the tight seating of the saw blade. A
loose saw blade can fall out and lead to injuries.
GST 65 E
GST 65 BE
PROFESSIONAL
3 601 E09 2..
400
230
500 – 3100
18
65
12
3
45
1.7
/ II
1 609 929 K70 • 24.10.06