Installing the power supply unit (PSU)
1
Place the power supply in the chassis and slide towards the back of the system to secure it.
2
Tighten the screws (6-32xL6.35) at the back of the computer to secure power supply.
3
Connect the 8-pin power cable to the system board.
4
Thread the power cables through the chassis clip.
5
Connect the 4-pin power cable to the system board.
6
Install the:
a
cooling shroud
b
front bezel
c
cover
7
Follow the procedure in
Speaker
Removing the speaker
1
Follow the procedure in
2
Remove the:
a
cover
b
front bezel
3
To remove the speaker:
a
Disconnect the speaker cable from system board [1].
After working inside your
computer.
Before working inside your
computer.
Removing and installing components
15