Care And Cleaning - Sharp YB-S4202AE Manual

CARE AND CLEANING

CLEAN THE OVEN AT REGULAR INTERVALS AND REMOVE ANY FOOD DEPOSITS - Keep the oven
clean, or the oven could lead to deterioration of the surface.This could adversely affect the life of the
appliance and possibly result in a hazardous situation.
VERY IMPORTANT CAUTIONS:
• DO NOT OPERATE THE OVEN WITHOUT
THE SPLASH COVER IN PLACE.
• DO NOT REMOVE THE SPLASH COVER
UNLESS THE POWER CORD IS REMOVED
FROM THE OUTLET BECAUSE THE ROTARY
ANTENNA, WHICH IS LOCATED ON THE
CEILING, OPERATES FOR 1 MINUTE AFTER THE
DOOR IS OPENED AND INJURY COULD OCCUR.
• D O N O T U S E C O M M E R C I A L O V E N
CLEANERS, ABRASIVE, HARSH CLEANERS
OR SCOURING PADS ON ANY PART OF
YOUR MICROWAVE OVEN.
• DO NOT SPRINKLE WATER ONTO THE
OVEN DIRECTLY. IT MAY CAUSE ELECTRIC
SHOCK, LEAKAGE OF ELECTRICITY OR
DAMAGE OF THE OVEN.
• THE OVEN SHOULD NOT BE CLEANED
WITH A WATER JET.
Oven Exterior
The outside of your oven can be cleaned easily with
mild soap and water. Make sure the soap is wiped off
with a moist cloth, and dry the exterior with a soft towel.
Control Panel
Open the door before cleaning to inactivate the control
panel keys. Care should be taken in cleaning the
control panel. Using a cloth dampened with water only,
gently wipe the panel until it becomes clean. Avoid the
use of excess water. Do not use any sort of chemical or
abrasive cleaner. To do so may cause severe damage
to the panel and make key entry impossible.
Oven Interior
1) For easy cleaning, wipe any spatters or spills
with a soft damp cloth or sponge at the end of
each day for hygienic reasons. For heavier spills,
use mild soap and wipe several times with a
damp cloth until all residues are removed.
Built-up splashes may overheat and begin to
smoke or catch fire, and cause arcing.
2) Keep the ceramic floor clean at all times. If you
leave grease or fat in the cavily, it may overheat,
smoke or even catch fire when next using the oven.
CAUTION:
DO NOT REMOVE THE CERAMIC FLOOR FROM
THE OVEN.
3) Make sure that mild soap or water does not
penetrate through the small vents in the walls
which may cause damage to the oven.
4) Do not use spray type cleaners on the oven
interior.
Splash cover
AT L E A S T O N C E A W E E K , R E M O V E T H E
SPLASH COVER AND WASH BOTH SIDES OF
IT IN A MILD DETERGENT SOLUTION. BUILT-
UP GREASE MAY OVERHEAT AND BEGIN TO
SMOKE. AND OVERHEATED GREASE MAY
BURN THE SPLASH COVER. THE SPLASH
COVER IS LOCATED IN THE TOP OF THE OVEN
AND MAY EASILY BE REMOVED. REMEMBER
TO UNPLUG THE POWER CORD.
Removal:
1. Remove two thumb screws (A) as shown in Fig. 1.
2. Remove the splash cover from the oven.
Reinstall:
1. Insert two projections of the cover (B) into the holes
of the oven cavity backplate as shown in Fig. 2.
2. Secure the cover to the oven ceiling with two
thumb screws (A) as shown in Fig. 1.
Door
(B)
Oven lamp replacement
Unplug the oven before removing the oven lamp
access cover, and replace the lamp (25W/240V).
Make sure that the cover is secured to the oven
cabinet after replacing the lamp.
EN-16
Fig. 1
Splash Cover
(A)
Fig. 2
Splash Cover
Holes