Sharp YB-S4202AE Manual page 11

Setting magnification factor
It is possible to change the magnification factor for double quantity in the memory.
Example : Suppose you want to set the magnification factor to 1.67 for double quantity in memory 1.
Step
1 Choose set mode.
2 Choose double quantity.
3 Choose memory number.
4 Touch MANUAL/REPEAT key.
5 Enter magnification factor.
6 Complete memorizing.
NOTE:
1. In case you want to change the magnification factor it must be set for each key separately.
2. The magnification factor can be set from 0.00 to 9.99.
3. At Step 1, any audible signals will not sound when the SET key is touched first and then an audible signal
will sound when the SET key is touched second.
MEMORY CHECK
You can check the information programmed into the memory.
Checking time and power level
Example : Suppose you want to know the information programmed into the memory 1, programmed for 4
minutes at 60% at the 1st sequence and 2 minutes at 30 % at the 2nd sequence, and after that the
memory 13, programmed for 3 minutes at 70 %.
Step
1 Choose checking mode.
2 Choose memory number.
3 Choose memory number.
4 Cancel checking mode.
NOTE:
When is displayed at step 2 or step 3, the memory is not set.
Action
Action
Press key
× 2
within 2 sec.
× 2
Press key
× 2
EN-10
Display
NUMBER
NUMBER
DOUBLE
NUMBER
DOUBLE
NUMBER
DOUBLE
NUMBER
DOUBLE
Display
CHECK
NUMBER
CHECK POWER
NUMBER
%
1
CHECK POWER
NUMBER
%
2
Repeat
CHECK POWER
NUMBER
%
1