Replacing The Drive Backplane Power Cable - IBM 9009-22A Manual
Drive backplanes
Hide thumbs
Also See for 9009-22A:
- Site and hardware planning (164 pages) ,
- Manual (150 pages) ,
- Instructions manual (32 pages)
Table of Contents
Advertisement
Figure 66. Disconnecting the signal cable and power cable
Replacing the drive backplane power cable in the 5105-22E, 9008-22L, 9009-22A,
9009-22G, 9223-22H, or 9223-22S system
To replace a drive backplane power cable in the system, complete the steps in this procedure.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
2. Using your labels, reconnect the power cable (B) to the drive backplane as shown in Figure 67 on page
76.
Push the connectors in until the latch clicks.
Drive backplane cables in the 5105-22E, 9008-22L, 9009-22A, 9009-22G, 9223-22H, or 9223-22S 75
Advertisement
Table of Contents
