Table of Contents
Advertisement
The Bluetooth Standard Pairing feature enables your
Bluetooth enabled radio to search for other Bluetooth
enabled and discoverable devices. Once a device is
discovered, you can initiate your radio to send a pairing
request to pair with the device.
This feature also enables your Bluetooth enabled radio to
be visible to other Bluetooth enabled devices and receive
request to pair from other devices.
The Standard Pairing feature supports pairing
Authentication Personal Pairing Number or PIN which
ensure your radio recognizes the correct device to pair.
The PIN must be exchanged with the radio or the device
before the pairing completes. Your radio prompts for the
Authentication PIN when needed. Refer to your device's
manual for details about the Bluetooth Authentication PIN
of your device if needed.
Searching and Pairing the Bluetooth
Device
Ensure the Bluetooth on your device is turned on and is set
to Discoverable in order to enable your radio to detect
your device in Bluetooth.
Send Feedback
Bluetooth Search in Bluetooth Standard Pairing method is
used to scan for other Bluetooth devices nearby. It is set to
turn off by default.
1 Perform one of the following actions:
•
Press the preprogrammed Bluetooth Search
button.
•
or
to BT. Press the Menu Select button
directly below BT to access the Bluetooth feature
screen.
or
the Menu Select button directly below On.
If successful, the display shows BT Searching
followed by the names of Bluetooth devices found, if
any. When the search timer expires, Available Dev
screen shows a list of Bluetooth devices found. To
stop the search before the search timer expires,
press the preprogrammed Bluetooth Search button
or the Menu Select button below Stop.
If the feature fails to initiate, the radio sounds a
short, low-pitched tone. The screen shows BT
Search failed. Press the Menu Select button below
Back to return to Bluetooth feature screen, or press
English
to Search Devices and press
147
Advertisement
Table of Contents
