To Arm The System; To Disarm The System; Rearming Of The System; Doors - Chrysler 300 2017 Owner's Manual

To Arm The System

Follow these steps to arm the vehicle security
alarm:
1. Make sure the vehicle's ignition is placed in
the OFF mode (refer to "Ignition Switch" in
this chapter for further information).
2. Perform one of the following methods to lock
the vehicle:
• Push lock on the interior power door lock
switch with the driver and/or passenger door
open.
• Push the lock button on the exterior Passive
Entry Door Handle with a valid key fob avail-
able in the same exterior zone (refer to "Key-
less Enter-N-Go — Passive Entry," located in
"Doors" in "Getting To Know Your Vehicle" for
further information).
• Push the lock button on the key fob.
3. If any doors are open, close them.
NOTE:
Security System Manual Override
The vehicle security alarm will not arm if you
lock the doors using the manual door lock
plunger.

To Disarm The System

The vehicle security alarm can be disarmed
using any of the following methods:
• Push the unlock button on the key fob.
• Grasp the Passive Entry Unlock Door
Handle, if equipped. Refer to "Keyless Enter-
N-Go — Passive Entry," located in "Doors" in
"Getting To Know Your Vehicle" for further
information.
• Push the Keyless Enter-N-Go ignition button
(requires at least one valid key fob in the
vehicle).
NOTE:
• The driver's door key cylinder and the trunk
button on the key fob cannot arm or disarm
the vehicle security alarm.
• When the vehicle security alarm is armed, the
interior power door lock switches will not
unlock the doors.
The vehicle security alarm is designed to protect
your vehicle. However, you can create condi-
tions where the system will give you a false
alarm. If one of the previously described arming
sequences has occurred, the vehicle security
alarm will arm regardless of whether you are in
the vehicle or not. If you remain in the vehicle
and open a door, the alarm will sound. If this
occurs, disarm the vehicle security alarm.
If the vehicle security alarm is armed and the
battery becomes disconnected, the vehicle se-
curity alarm will remain armed when the battery
is reconnected; the exterior lights will flash, the
horn will sound. If this occurs, disarm the vehicle
security alarm.

Rearming Of The System

If something triggers the alarm, and no action is
taken to disarm it, the vehicle security alarm will
turn the horn off after 29 seconds, five seconds
between cycles, up to eight cycles if the trigger
remains active and the vehicle security alarm
will rearm itself.

DOORS

Manual Door Locks

To lock each door, push the door lock knob on
each door trim panel downward. To unlock the
front doors, pull the inside door handle to the
first detent. To unlock the rear doors, pull the
door lock knob on the door trim panel upward.
Door Lock Knob
27