Closing Power Shade; Venting Sunroof - Express; Pinch Protect Feature; Sunroof Maintenance - Chrysler 300 2017 Owner's Manual

Closing Power Shade

Express
Push the switch forward and release it within
one-half second and the shade will close auto-
matically from any position. If the sunroof is
completely closed the shade will close fully and
stop automatically. This is called "Express
Close". During Express Close operation, any
movement of the switch will stop the shade.
NOTE:
If the sunroof is open, the shade will close to the
half-open position. Pushing the shade close
button again will automatically close both the
sunroof and shade completely.
Manual
To close the shade, push and hold the switch in
the forward position. Any release of the switch
will stop the movement and the shade will
remain in a partially closed condition until the
switch is pushed again.
Venting Sunroof — Express
Push and release the "Vent" button within one-
half second and the sunroof will open to the vent
position. This is called "Express Vent", and it will
occur regardless of sunroof position. During
Express Vent operation, any movement of the
switch will stop the sunroof.
62
NOTE:
If the sunshade is in the closed position when
the vent switch is pushed, the sunshade will
automatically cycle to the halfway open position
prior to the sunroof opening to the Vent position.

Pinch Protect Feature

This feature will detect an obstruction in the
closing of the sunroof during the Express Close
operation. If an obstruction in the path of the
sunroof is detected, the sunroof will automati-
cally retract. Remove the obstruction if this
occurs.
NOTE:
If three consecutive sunroof close attempts re-
sult in Pinch Protect reversals, Pinch Protect will
disable and the sunroof must be closed in
Manual Mode.

Sunroof Maintenance

Use only a non-abrasive cleaner and a soft cloth
to clean the glass panel.

Ignition Off Operation

NOTE:
• The power sunroof switch can remain active
in Accessory Delay for up to approximately
ten minutes after the vehicle's ignition is
placed to the OFF position. Opening either
front door will cancel this feature.
• This feature is programmable using the
Uconnect System. Refer to "Uconnect Set-
tings" in "Multimedia" for further information.

HOOD

To Open The Hood

Two latches must be released to open the hood.
1. Pull the hood release lever located under the
driver's side of the instrument panel.
Hood Release Lever
2. Move to the outside of the vehicle and push
the safety catch to the left. The safety catch
is located under the center front edge of the
hood.