Command Table - BenQ W2710 Installation Manual

Command table

• Available features differ by projector specification, input sources, settings, etc..
• Commands are working if the standby power is 0.5W or a supported baud rate of the projector is
set.
• Uppercase, lowercase, and a mixture of both types of characters are accepted for a command.
• If a command format is illegal, it will echo Illegal format.
• If a command with correct format is not valid for the projector model, it will echo Unsupported
item.
• If a command with correct format cannot be executed under certain condition, it will echo Block
item.
• If RS232 control is performed via LAN, a command works whether it starts and ends with <CR>. All
the commands and behaviors are identical with the control through a serial port.
Function Type
Write
Power
Write
Read
Write
Write
Write
Write
Write
Write
Write
Write
Write
Source
Write
Selection
Write
Write
Write
Write
Write
Write
Write
Write
Write
Read
Write
Audio Control
Write
Read
Operation
Power On
Power off
Power Status
COMPUTER/YPbPr
COMPUTER 2/YPbPr2
COMPUTER 3/YPbPr3
Component
Component2
DVI-A
DVI-D
HDMI(MHL)
HDMI 2(MHL2)
HDMI 3
Composite
S-Video
Network
USB Display
USB Reader
HDbaseT
DisplayPort
3G-SDI
Smart System
Current source
Mute On
Mute Off
Mute Status
ASCII
<CR>*pow=on#<CR>
<CR>*pow=off#<CR>
<CR>*pow=?#<CR>
<CR>*sour=RGB#<CR>
<CR>*sour=RGB2#<CR>
<CR>*sour=RGB3#<CR>
<CR>*sour=ypbr#<CR>
<CR>*sour=ypbr2#<CR>
<CR>*sour=dviA#<CR>
<CR>*sour=dvid#<CR>
<CR>*sour=hdmi#<CR>
<CR>*sour=hdmi2#<CR>
<CR>*sour=hdmi3#<CR>
<CR>*sour=vid#<CR>
<CR>*sour=svid#<CR>
<CR>*sour=network#<CR>
<CR>*sour=usbdisplay#<CR>
<CR>*sour=usbreader#<CR>
<CR>*sour=hdbaset#<CR>
<CR>*sour=dp#<CR>
<CR>*sour=sdi#<CR>
<CR>*sour=smartsystem#<CR>
<CR>*sour=?#<CR>
<CR>*mute=on#<CR>
<CR>*mute=off#<CR>
<CR>*mute=?#<CR>
10
Support
YES
YES
YES
NO
NO
NO
NO
NO
NO
NO
YES
YES
YES
NO
NO
NO
NO
YES
NO
NO
NO
NO
YES
YES
YES
YES