Command Table - BenQ LW500 Installation Manual

Command table

• Available features differ by projector specification, input sources, settings, etc..
• Commands are working if the standby power is 0.5W or a supported baud rate of the projector is
set.
• Uppercase, lowercase, and a mixture of both types of characters are accepted for a command.
• If a command format is illegal, it will echo Illegal format.
• If a command with correct format is not valid for the projector model, it will echo Unsupported
item.
• If a command with correct format cannot be executed under certain condition, it will echo Block
item.
• If RS232 control is performed via LAN, a command works whether it starts and ends with <CR>. All
the commands and behaviors are identical with the control through a serial port.
Function
Power
Source Selection
Audio Control
Type Operation
Write Power On
Write Power Off
Read Power Status
Write COMPUTER/YPbPr
Write COMPUTER 2/YPbPr2
Write COMPUTER 3/YPbPr3
Write Component
Write Component2
Write DVI-A
Write DVI-D
Write HDMI(MHL)
Write HDMI 2(MHL2)
Write Composite
Write S-Video
Write Network
Write USB Display
Write USB Reader
Write HDBaseT
Write DisplayPort
Write 3G-SDI
Write Smart System
Write Wireless Display
Read Current source
Write Mute On
Write Mute Off
Read Mute Status
ASCII
<CR>*pow=on#<CR>
<CR>*pow=off#<CR>
<CR>*pow=?#<CR>
<CR>*sour=RGB#<CR>
<CR>*sour=RGB2#<CR>
<CR>*sour=RGB3#<CR>
<CR>*sour=ypbr#<CR>
<CR>*sour=ypbr2#<CR>
<CR>*sour=dviA#<CR>
<CR>*sour=dvid#<CR>
<CR>*sour=hdmi#<CR>
<CR>*sour=hdmi2#<CR>
<CR>*sour=vid#<CR>
<CR>*sour=svid#<CR>
<CR>*sour=network#<CR>
<CR>*sour=usbdisplay#<CR>
<CR>*sour=usbreader#<CR>
<CR>*sour=hdbaset#<CR>
<CR>*sour=dp#<CR>
<CR>*sour=sdi#<CR>
<CR>*sour=smartsystem#<CR>
<CR>*sour=wireless#<CR>
<CR>*sour=?#<CR>
<CR>*mute=on#<CR>
<CR>*mute=off#<CR>
<CR>*mute=?#<CR>
10
Support
YES
YES
YES
NO
NO
NO
NO
NO
NO
NO
YES
YES
NO
NO
NO
NO
NO
NO
NO
NO
NO
NO
YES
YES
YES
YES