1-2. Opening, closing and locking the doors
■
Switching the door unlock function
If it is possible to set which doors the entry function unlocks.
STEP
1
Turn the "ENGINE START STOP" switch OFF.
When the indicator on the key surface is turned off, press and hold
STEP
2
pressing
The setting changes each time an operation is preformed, as shown below.
(When changing the setting continuously, release the buttons, wait for at
least 5 seconds, and repeat
Multi-information
display
STEP
3
For vehicles equipped with an alarm, unlock the doors using the
electronic key and open one of the doors.
If a door is not opened within 30 seconds after
doors will be locked again and the alarm will automatically be set.
In case that the alarm is triggered, immediately stop the alarm.
(→P. 99)
30
or
(if equipped) for approximately 5 seconds while
on the key.
STEP
2
Unlocking function
Hold the driver's door
handle to unlock only
the driver's door.
Hold either door han-
dle to unlock all doors.
.)
Exterior: Beeps three
times
Interior: Pings once
Exterior: Beeps twice
Interior: Pings once
Beep
is pressed, the