1-7. Processing of Flexible Flat Cable with Connector and Harness of
Bottom Cover Assembly
1-7-1. Flexible Flat Cable with Connector
n
. When replacing the bottom cover assembly, remove the flexible flat cables with connector (hereafter
referred to as FFC) in the order from 1 to 3, and attach them in the order from 3 to 1.
. When replacing FFC, follow the instructions below.
. When replacing FFC 1: Replace it by removing only FFC 1.
. When replacing FFC 2: Replace it by removing only FFC 1.
. When replacing FFC 3: It is required to remove FFC 2.
Rear side
1-20 (E)
Rear side
Three flexible flat cables
with connectors
3
Bottom cover assembly
(upper side)
Bottom cover assembly
(bottom side)
1
2
3
1
2
Hole
VPL-VW520