Reading Of Adjustment Data - Sony VPL-VW528 Service Manual

3-4. Reading of Adjustment Data

The procedure for obtaining the 3DGamma/LookUpTable/CSMatrixTable/UGM/SLC/panel chiral/optical
unit assembly shift/panel alignment data/color sensor/serial data from the board is as follows.
Creating the USB memory for reading
1. Prepare the USB memory.
2. Create a file named "IneedFactory" directly under the drive of the USB memory.
*: The file other than "IneedFactory" should not exist in the folder.
Reading of adjustment data
1. Prepare the USB memory for reading.
2. Insert the USB memory into this unit.
3. Connect the power cord to this unit.
4. Wait for 1 minute.
5. Disconnect the power cord from this unit.
6. Pull out the USB memory from this unit.
7. Check that the following files are created in the USB memory.
CSMatrixTable.csv
ColorSensorMatrixTable
OptUnit.csv
pd_slc.csv
pd_uf.csv
pd_gamma.csv
pd_ugm.csv
pd_bpc.csv
pd_clk.csv
pd_dwec.csv
pd_dwec_ratio.csv
pd_pwm.csv
pd_regi_lens_adj.csv
pd_uf_std.csv
pd_gamma_std.csv
SetSerial.csv
3-4 (E)
VPL-VW520