Table of Contents
Advertisement
TeamPos 3000XT
8.2
System will not boot up
(The system fails to start up even though the power is turned on)
No
Check item
Is data displayed on the monitor
1
during Power On Self Test
(POST)?
Is there an error message displayed
2
on the monitor?
Does the system get through the
3
POST without hanging up?
Replace memory – Does system
4
get through POST?
Replace CPU chip – Does system
5
get through POST?
Replace motherboard – Does
6
system get through POST?
Can BIOS be accessed by hitting
7
F2 during POST?
Has the system(O/S)been
8
installed?
Can the system boot up in "Safe
9
Mode" by hitting F8 during POST?
Is the HDD cable connected?
10
Can the system boot up from a
bootable USB key or bootable CD
11
by changing the BIOS to boot from
that device first?
Can the system be started after
12
replacing the motherboard?
Can the system be started after
13
replacing the HDD and reloading
the O/S?
Can the system be started after
14
replacing the power supply?
8-2
Installation and Maintenance Manual
Judgment Action
Y
Go to No.2., or go to LCD
troubleshooting section if display
goes blank after POST.
N
Go to LCD troubleshooting section
if no display.
Y
See the POST message & act
accordingly.
N
Go to No.3.
Y
Go to No. 7.
N
Go to No. 4.
Y
End.
N
Go to No. 5.
Y
End.
N
Go to No. 6.
Y
End.
N
Go to No. 13.
Y
Load BIOS Defaults/Save &
Exit/Go to #8.
N
Go to No. 12.
Y
Go to No.9.
N
Install O/S and reboot.
Y
O/S or driver reload is probably
required.
N
Go to No. 10.
Y
Go to No.11.
N
Connect the cable.
Y
Reload O/S and reboot – If unable
to load O/S go to No. 13.
N
Go to No. 12.
Y
End.
N
Go to No.13.
Y
End.
N
Go to No.14.
Y
End.
N
Change the whole unit.
D900000172
Advertisement
Table of Contents
