Table of Contents
Advertisement
TeamPoS 3000 XT
4. Remove the three screws that retain the back panel. Remove the screws that secure one of
the brackets using a Philips head screwdriver. The panel will fold down and the power
supply will slide out.
Remove
three
screws
5. Disconnect the power supply cables.
6. Remove the power supply and replace it.
7. Reconnect the cables and route them under the brackets, secure the bracket.
8. Replace the back panel and secure it with the three screws removed in step 4.
9. Replace the power supply back cover.
Note: Earlier models had a battery cable connected to the power supply. This cable needs to be
removed before replacing the power supply. This requires removing the side panel and the cable
clamp.
7.3.8.
I/O Panel
The I/O panel is not field replaceable.
7-14
Installation and Maintenance Manual
Remove Philips
head screw
D900000172
Advertisement
Table of Contents
