TeamPoS 3000 XT
7.3.5.
Adding or Replacing Memory
Caution: Be sure to observe all ESD precautions and power off procedures.
The TeamPoS 3000 XT has two memory sockets (slots) and can use 256MB, 512MB or 1GB
memory in combination.
To add or replace memory:
1. Remove the AC cord from the back of the terminal.
2. Remove the motherboard as described in section 7.3.1, steps 1 – 6.
3. Flip the memory socket levers to the open position.
4. Insert memory (or additional memory) into an empty socket. (There is only one way the
memory stick will fit.)
5. Lock both socket levers into place to secure the new memory.
6. If this is an upgrade, attach the upgrade label that comes with the upgrade kit on the back
of the unit near the serial number.
7. Replace the motherboard as described in section 7.3.1, steps 7-13.
D900000172
Figure 7-10. Adding/Replacing Memory
Installation and Maintenance Manual
Memory
7-11