Table of Contents
Advertisement
For the installer and kitchen
expert!
Important installation notes:
Properly dispose of packaging
materials.
Do not use oven door handle for trans-
porting or handling the unit during
installation.
WARNING: Connection and first start of
the appliance may only be performed by
an authorised specialist.
Connection must be made using an
H 0 5 V V- F mains connection cable.
Nominal connected loading, nominal
voltage and model number of the
appliance:
see the rating plate, located behind the
oven door, fixed to the lower left facing
edge of the oven.
The unit's nameplate is located at on
the right sidewall of the unit.
Electrical safety of the appliance can
be ensured only if the equipment earth
in the building installation has been
installed according to regulations.
On the installation side a isolating device
shall be provided.
Any switch with a contact gap ex-
ceeding 3 mm may be considered
a separating device.
Other examples are LS switches, fuses
and contactors.
In the case of repairs interrupt all
power connections to the unit.
Connection diagram:
~
220-240V
22
Assembly Instructions
L
N
Kitchen furniture
Oven housing units from virtually all lines of
kitchen furniture are suitable for installing the
built-in oven. However, the veneers or plastic
laminates on the housing unit must be
applied with heat-resistant cement (90 °C). If
plastic laminates or cement are not
sufficiently heat-resistant, warping, bubbling
or detachment of the finish may result.
Advertisement
Table of Contents
