Gigabyte GA-Z87X-UD7 TH User Manual page 74

Recovery Volume Options
Intel Rapid Recover Technology provides data protection by allowing users to easily restore data and system
®
operation using a designated recovery drive. With the Rapid Recovery Technology, which employs RAID 1
functionality, users can copy the data from the master drive to the recovery drive; if needed, the data on the
recovery drive can be restored back to the master drive.
Before you begin:
• The recovery drive must have equal or greater capacity than the master drive.
• A recovery volume can be created with two hard drives only. A recovery volume and a RAID array cannot
co-exist in the system at the same time, that is, if you have already created a recovery volume, you are
unable to create a RAID array.
• By default, only the master drive can be viewed in the operating system; the recovery drive is hidden.
Step 1:
Select Create RAID Volume in MAIN MENU and press <Enter> (Figure 15).
Intel(R) Rapid Storage Technology - Option ROM - 12.0.0.1783
Copyright(C) 2003-13 Intel Corporation. All Rights Reserved.
1. Create RAID Volume
2. Delete RAID Volume
3. Reset Disks to Non-RAID
RAID Volumes :
None defined.
Physical Disks :
IE Drive Model
0 ST3120026AS
1 ST3120026AS
[hi]-Select
Step 2:
After entering the volume name, select Recovery under the RAID Level item and press <Enter> (Figure 16).
Intel(R) Rapid Storage Technology - Option ROM - 12.0.0.1783
Copyright(C) 2003-13 Intel Corporation. All Rights Reserved.
[hi]-Change
Configuring SATA Hard Drive(s)
[ MAIN MENU ]
[ DISK/VOLUME INFORMATION ]
Serial #
3JT354CP
3JT329JX
[ESC]-Exit
Figure 15
[ CREATE VOLUME MENU ]
Name : Volume0
RAID Level : Recovery
Disks : Select Disks
Strip Size : N/A
Capacity : 111.7 GB
Sync : Continuous
Create Volume
[ HELP ]
Recovery: Copies data between a master and a recovery disk.
[TAB]-Next [ESC]-Previous Menu
Figure 16
- 74 -
4. Recovery Volume Options
5. Acceleration Options
6. Exit
Size Type/Status(Vol ID)
111.7GB Non-RAID Disk
111.7GB Non-RAID Disk
[ENTER]-Select Menu
[ENTER]-Select