Safety Advice - Apex Digital dB Series User Manual

SAFETY ADVICE

CAUTION: To reduce the risk of electric shock, do not remove the cover, back or front. No user
serviceable parts inside. Refer servicing to qualified service personnel.
SAFETY ADVICE
The lightning flash with arrowhead symbol within an equilateral triangle, is intended to alert the user
to the presence of un-insulated "dangerous voltages" within the product's enclosure that may be of
sufficient magnitude to constitute a risk of electric shock.
CAUTION: To reduce the risk of electric shock, do not remove the cover, back or front. No user ser-
viceable parts inside. Refer servicing to qualified service personnel.
The exclamation point within an equilateral triangle is intended to alert the user to the presence
of important operating and maintenance (servicing) instructions in the literature accompanying the
The lightning flash with arrowhead symbol within an equilateral triangle, is intended to alert the user
appliance.
to the presence of un-insulated "dangerous voltages" within the product's enclosure that may be of
sufficient magnitude to constitute a risk of electric shock.
IMPORTANT
The exclamation point within an equilateral triangle is intended to alert the user to the presence of
Do not modify the power cord .
important operating and maintenance (servicing) instructions in the literature accompanying the appli-
If the power cord does not correspond with the power cord you need or if it is too short to connect to
ance.
the power socket, please buy a certified power cord at a distributor.
If the power cord is damaged in any way, please replace the cord with a new certified power cord.
If the power cord is not equipped with a power plug, please follow these instructions carefully:
IMPORTANT: The wire colour codes correspond with the following:
GREEN / YELLOW:
BLUE:
BROWN:
ATTENTION: This device must be grounded.
If these colours do not correspond with the symbols or colours you are using, please follow the fol-
lowing instructions:
The GREEN / YELLOW wire must be connected to the connector representing the letter E, the
grounding symbol ( ) or the colour GREEN.
The BLUE wire must be connected to the connector represented by the letter N or the colour
BLACK.
The BROWN wire must be connected to the connector represented by the letter L or the colour
RED.
If in any case you need to replace a fuse, please make sure that you use the same value and that
you correctly reposition the protective cover for the fuse.
IN CASE OF DOUBT, PLEASE CONTACT A COMPETENT TECHNICIAN
GROUND
NEUTRAL
PHASE / LIVE