Table of Contents
Advertisement
º
Ò
‡
TV
SWAP
PIP CH
DN
SOUND
STATUS/
EXIT
VOL
1
4
7
TV/VCR
A/CH
POSITION
SOUND
Working with accessory devices
26
Setting the remote control to work accessory devices
π
†
VCR
ACC
VCR
ACC
ACTIVE
CONTROL
FREEZE
ê
UP
PICTURE
MENU/
SELECT
MENU/
SELECT
MUTE
&
¬
CH
2
3
5
6
SURF
8
9
é
0
SURF
"
PIP
l
PICTURE
'
&
é
"
Your remote control is set to work your TV and many infrared remote (IR) control
VCRs, Cable TV Converter Boxes, DVD players, Satellite Receivers, etc.
Press the
or
button according to the accessory device you want to
VCR
ACC
operate with this remote control.
If the function buttons on the remote control also work the selected
accessory device, then the remote is ready and no further steps are needed.
If the functions buttons do not work the selected accessory device
According to the device(s) you own, you may make your remote control ready
for them by a direct entry code. Proceed as following.
Look up a three-digit remote control number for your brand of devices.
See pages 27-28.
If more than one number is listed, you may have to try more than one code in
order to locate your device's remote code.
Press and hold the proper device button
simultaneously the
MENU/SELECT
Enter, within 30 seconds, the three-digit remote code number for your desired
device.The remote is now ready to send commands to the unit.
Note: If no code or an incomplete code is entered within 30 seconds, the backlight
and selected mode button will turn off and give a long blink before returning to
the previous programmed code.
Point the remote at the device.
Press the
button on the remote to turn the unit on.
POWER
Remember: If this doesn't work the first time, repeat the steps using the same
remote code number. After second try and the remote does not operate your
device, see if there is another four-digit code number listed for your device.
Repeat the steps above using the new number.
If, after repeated attempts, the remote does not work your device, try the Auto
Search method following.
Auto Search method
Turn on the desired device by pressing the
are attempting to program.
Press and hold the proper mode button
simultaneously the
button, then release.
SURF
The device will begin to change channels after the remote identifies the
correct code.
When the channels start to change, release the
The remote should be ready to operate the device
Note: If any other button is pressed during Auto Search, the search will be
ended. The remote keeps its previous code.
For devices DVD and CD, insert a disc and press
The remote control will send the command next track.
Switch AV receivers to
TUNER
This method can take up to two minutes to perform.
Don't let the device change more than five channels after the remote identifies
the code.
If no channel change happens within two minutes, repeat the steps mentioned
above. Should a channel change still not occur, the remote will not work the
desired device.
or
and press
VCR
ACC
button, then release.
button on the device you
POWER
or
and press
VCR
ACC
and
VCR
on the device.
PLAY
function.
buttons.
SURF
Advertisement
Table of Contents
