Table of Contents
Advertisement
Art 40-60
User guide
Switching the TV set ON/OFF
Switching the TV set ON/OFF
Switching TV set to the standby mode
Press the mains switch at the bottom of the set.
The indicator in the control panel on the front side lights up white. The
set is now in standby mode.
M
-
+
R
Control unit
Mains switch
Switching the TV on/off on the control unit
To switch the TV set into Operating mode or switch it off to Standby
mode, press the middle of the On/Off button for about 2 seconds.
Display
Meaning of the colour of the LEDs in the On/Off button:
white:
TV set in standby
white, intermittent: TV set starts
green:
TV set switched on
red:
Timer recording active
blue:
TV set in standby and background opera-
tion active (EPG data updating, software
update, DR+ streaming server function)
After switching on the TV set, it takes a few seconds for further
operating commands to be processed (Exception: Quick start
mode, see chapter System settings, section Control – Quick
start mode). Your TV set is ready to operate as soon as the status
indicator in the control panel lights up in green.
Switching the TV set on by means of the remote control
Press the on/off key.
Or:
Press the TV key.
The previously watched station will be called.
Or:
Press numerical keys 1-9.
The corresponding station will be called.
After switching on the TV set, it takes a few seconds for further
operating commands to be processed (Exception: Quick start
mode, see chapter System settings, section Control – Quick
start mode). Your TV set is ready to operate as soon as the status
indicator in the control panel lights up in green.
Switching the set off with the remote control (Standby)
Press the on/off key.
Before switching off the set with the mains switch,
we recommend you to switch it to standby mode.
Switching off the TV set and connected additional devices
(System standby)
Press on/off key long:
Switch TV set and all CEC-capable devices connected
to the HDMI interfaces OFF to Standby mode (System
Standby).
Technical information
Switching off the TV set with the mains switch during operation or an
inadvertent disruption to the power supply (e.g., power failure) can
cause damage to the USB hard disk file system and hence loss of the
recorded broadcasts. Always return the TV set to Standby mode
before switching it off with the main switch.
However, if unexpected problems occur when operating the hard disk,
formatting the hard disk may rectify this. You can find the correspon-
ding menu items under System settings
Hard disks.
Loewe is not liable for data being lost from USB hard disks.
Control
more ....
15
Advertisement
Table of Contents
