Pressure Control Replacement
WARNING
Do not attempt to adjust or calibrate the pressure
control. If the pressure control is faulty, replace it.
302
304
303
304
310
Fig. 19
301
L2
11. Reassemble in the reverse order; attach earth or
ground wire (C), power leads (L1 and L2), the red
leads to the TS terminals on the circuit board (B1),
the M+ and M– leads, and the potentiometer cable
to the connector on B1. Attach the pressure con-
trol board/cover (301) using the four mounting
screws and washers (302, 303, 304),
L1
B1
C
317