Assembly - Bissell CLEANVIEW 1813 Series User Manual

Assembly

The only tool you will need to assemble
your vacuum is a Phillips screwdriver.
1
Place handle on
vacuum base and
press down firmly.
3
Place extension wand clip on back
of unit, twist clockwise to lock in.
5
Wrap hose up and around the
hose wrap on the handle. Slide
end of hose into vacuum base.
NOTE: The powerfoot will not suction properly unless the hose is firmly attached.
2
Insert screws in
back of unit.
Tighten by rotating
the screw clockwise
until tightened.
4
Line up tabs on hose end to vacuum base and
twist clockwise to lock in.
6
Store
TurboBrush®
on front of
handle.
7
Store dusting
brush above hose
wrap in holder.
www.BISSELL.com
5