Bissell CLEANVIEW 1813 Series User Manual page 9

Maintenance: Brush & Belt
1
Unplug vacuum, turn over and unscrew
six (6) Philips head screws to remove
the bottom cover.
3
End Cap
NOTE: If an object becomes lodged in foot and brush shuts off, turn vacuum off and
unplug from electrical outlet. Remove obstruction and brush will automatically reset when
vacuum is plugged and turned back on.
Maintenance: TurboBrush
1
Align
Slot
Twist gray collar
counter clockwise,
until slot appears,
then separate
faceplate.
Belt
2
Remove brush roll,
belt, and paddle
wheel. Inspect
for damages and
replace if necessary.
2
Thread belt and line up
End Cap to reassemble
roller. Replace bottom
cover and 6 screws.
®
& TurboEraser
3
Paddle Wheel
Clip
Paddle Wheel End
To reassemble, align two clips on each
end of paddle wheel with belt on and
pop back into place.
Place brush roll with belt back in.
Faceplate will not close properly if all
parts are not aligned correctly.
Clean debris from
brush roll. Inspect
by placing it on its
end and spin. The
brush roll should
spin freely, multiple
times by one flick.
If it doesn't, replace
brush roll.
Check belt for wear
or cuts and replace
if necessary.
Tool
®
www.BISSELL.com
Roller
Belt
9