Indoor Unit Installation Drawings - Daikin FTXG20LV1BS Installation Manual

Indoor Unit Installation Drawings

The mounting plate should be
installed on a wall which can
support the weight of the
indoor unit.
30mm or more
from ceiling
50mm or more
from walls
(on both sides)
Air filters
B Titanium apatite photocatalytic
air-purifying filter (2)
Filter frame
Tab
Claw
INTELLIGENT EYE sensor
CAUTION
• Do not hit or violently push the INTELLIGENT EYE sensor. This can lead to damage and malfunction.
• Do not place large objects near the sensor. Also keep heating units or humidifiers outside the sensor's detection area.
■
English
A Mounting plate
G Screw cover
Lower front panel
Service lid
The service lid is removable.
Titanium apatite
photocatalytic
air-purifying filter
Air filter
How to attach the indoor unit
Hook the claws of the bottom
frame to the mounting plate.
If the claws are difficult to hook,
remove the front grille.
Upper front panel
Make sure that there are no obstacles within
500mm under the signal receiver.
Such obstacles, if any, may have an adverse
influence on the reception performance of
the receiver and the reception distance may
be shortened.
Opening method
1) Remove the service lid screws.
2) Pull out the service lid diagonally
down in the direction of the arrow.
3) Pull down.
Front grille
* When dismounting the front grille, refer
to "Removing and installing the front grille"
on page 4.
INTELLIGENT EYE sensor
500mm
or more
A Mounting
plate
Clip
Bottom frame
Caulk pipe hole
gap with putty.
Cut thermal insulation pipe
to an appropriate length and
wrap it with tape, making
sure that no gap is left in the
insulation pipe's cut line.
Wrap the insulation
pipe with the
finishing tape from
bottom to top.
C Wireless remote controller
Before screwing the
remote controller
holder to the wall,
make sure that
control signals are
properly received
by indoor unit.
D Remote controller
holder
3