Daikin FTXG20LV1BS Installation Manual page 14

Indoor Unit Installation
Wiring diagram parts table
A1P~A3P ............... Printed circuit board
BZ .......................... Buzzer
FG.......................... Frame ground
FU1,FU2 ................ Fuse
H1P,H2P ................ Pilot lamp
M1F........................ Fan motor
M1S,M2S,M3S....... Swing motor
M1.......................... Stepping motor
R1T,R2T................. Thermistor
S25~S200 .............. Connector
S1C........................ Limit switch
S1W ....................... Operation switch
X1M ....................... Terminal strip
....................... Protective earth
7.
Drain piping
1) Connect the drain hose, as described right.
2) Remove the upper front panel and the air filters.(Refer to removal method on page 4.)
Pour some water into the drain pan to check the water flows smoothly.
3) When drain hose requires extension, obtain an extension hose with an inner
diameter of 16mm.
Be sure to thermally insulate the indoor section of the extension hose.
4) When connecting a rigid polyvinyl chloride pipe
(nominal diameter 13mm) directly to the drain
hose attached to the indoor unit as with
embedded piping work, use any commercially
available drain socket (nominal diameter 13mm)
as a joint.
12
CAUTION
Note that operation will restart automatically if the main power supply is
turned off and then back on again.
HIGH VOLTAGE – be sure to discharge the capacitor completely
before repair work.
Risk of failure or water leakage!
Do not wash the inside of the air coditioner by yourself.
Drain hose supplied with Commercially available
the indoor unit drain socket
(nominal diameter 13mm)
The drain hose should
be inclined downward.
No trap is permitted.
Do not put the end
of the hose in water.
Indoor unit Extension drain hose
drain hose
Heat insulation tube (field supply)
Commercially available
rigid polyvinyl chloride pipe
(nominal diameter 13mm)
■
English