Table of Contents
Advertisement
Message
Close
top cover
Device busy
Duplex disabled
Press GO
Enter Account
Envelope mode
Error.Power off.
F###
Error.Power off.
F000
Exceeded Max.out
Press GO
File not found
Press GO
Format error
Hard disk
Format error
Memory card
Hard disk err ##
Press GO
ID error
Illegal Account
Press GO
Install MK
Troubleshooting
Corrective Action
The top cover of the printer is open. Close the printer top cover.
This message is displayed when Remove Device was selected while a USB memory was
being used.
The previous screen is displayed again 1 or 2 seconds.
You attempted to print with a paper size and paper type that cannot be used for duplex
printing. Press [GO] to print onto one-side of the paper only.
An account code must be entered. This message is displayed if you try to print from the
operation panel (e.g. printing a status page or using the Job Retention function) when the Job
Accounting function is enabled. For more information, refer to Job Accounting (Job
Accounting selection/setting) section of the Advanced Operation Guide.
Displayed when the envelope switch is set to envelope mode.
If the Attention indicator is flashing, check the installed optional hard disk or the memory card
format.
Turn the power switch off and then back on again. If this message still remains, turn the
power switch off, and contact your service representative or authorized service center.
The printer controller and operation panel cannot exchange data. Turn the printer off and
unplug it from the mains power supply. Then contact your service representative or
authorized service center. See the back page of this manual for the relevant phone numbers.
This message is displayed when the Job Accounting function is enabled and an attempt has
been made to exceed the print limit set for each account. To return the printer to the print-
ready status, press [GO].
For more information, refer to Job Accounting (Job Accounting selection/setting) section of
the Advanced Operation Guide.
The specified file was not found on the hard disk, RAM disk or memory card. For more
information on the hard disk, RAM disk and memory cards, refer to Device Common
(Selecting/Setting the common device) section of the Advanced Operation Guide.
The hard disk installed in the printer is not formatted, and therefore cannot be read or written.
The memory card inserted in the printer is not formatted, and therefore cannot be read or
written. To format a memory card, follow the procedure in Memory Card (Using the memory
card) section of the Advanced Operation Guide.
A hard disk error has occurred. Look at the error code given in place of ## and refer to
Storage Error Codes on page 4-10. To ignore the hard disk error, press [GO].
The user ID entered for a private job is not correct. Check the user ID that you specified on
the printer driver. For more information, refer to Job Box section of the Advanced Operation
Guide.
This message is displayed when the Job Accounting function is enabled and no account is
set for a transmitted print job or the specified account is not registered (the incorrect account
is set). To return the printer to the print-ready status, press [GO].
For more information, refer to Job Accounting (Job Accounting selection/setting) section of
the Advanced Operation Guide.
Replace Maintenance Kit which is displayed on the message display. Replacement of the
maintenance kit is necessary at every 200,000 images of printing and requires professional
servicing. Contact your service technician.
4-7
Advertisement
Table of Contents
