Basic Antenna Connection - Magnavox 13MT143S - 13" Color Tv Owner's Manual

A
combination antenna receives normal
broadcast channels (VHF 2-13 and UHF
14-69).Your connection is easy since there is
only one 75 (ohm) antenna plug on the
back of your TV - and that's where the anten-
na goes.
1
If your antenna has a round cable
(75 ohm) on the end, then you're ready
to connect it to the TV. Go to step 2.
If your antenna has flat twin-lead
wire (300 ohm), you first need to attach
the antenna wires to the screws on a
300 to 75 ohm adapter (not supplied
with TV).
2
Push the round end of the adapter or
antenna cable onto the 75
rear of the TV. If the round end of the
antenna cable is threaded, screw it down
tight.
If no Video Signal is present, the TV will
display a "BLUE" screen and shut itself
off in about 5 minutes. If the TV is tuned
to the AV channel and there is no Video
Signal present, the screen will remain
black and the TV will shut itself off in
about 5 minutes.
Helpful Hints
If you are not using Cable TV,
set CABLE to NO. See the
Cable TV Control section on
page 11.
To set the TV to select only
the channel numbers in your
area, see Auto Program on
page 12.

Basic Antenna Connection

Combination
jack on the
VHF/UHF Antenna
(Outdoor or Indoor)
If you have separate UHF and VHF antennas, you need an
optional combiner to connect the antennas to the TV.
UHF Antenna
VHF Antenna
VHF Antenna
300 to 75
Adapter
Twin Lead Wire
Round Cable 75
U/V Combiner
75-300 Ohm Adapter
6
75
Rear of TV
75
75
Rear of TV