Table of Contents
Advertisement
When the safety device works by abnormal swing of spin drum, machine works automatically to
stop Spin-Dry cycle and operates water supply valve to pour water into the Wash/Spin Tub and
then starts washing cycle for replacing washing clothes evenly.
After above operation has down twice, if safety device works again, machine will stop, and the
number window LED display abnormal code:
and the electric buzzer sounds to indicate a problem.
• Open the Wash Lid and rearrange the clothes evenly around the Wash/Spin Tub.
• Close the Wash Lid and press the START/PAUSE button again.
f. Buzzing and rattling
Buzzing/rattling
Is high water
INSPECTION
INSPECTION
during water
pressure (more
supply.
than 4kg/cm
TROUBLE
INSPECTION
INSPECTION
Buzzing/rattling
Does some noise
during washing
sound during
or rinsing.
spin drying?
Buzzing/rattling
Is sound in
during spin-dry.
low-pitched
monotone?
Automatic
adjustment or
load.
and begin blinking on and off at the same time
Low
Something in water valve.
2
)?
High
Faucet open too far
CAUSES
Belt is slipping.
Yes
Pulley is loose.
Some part touch motor
No
Something underneath
pulsator.
Pulsator is rubbing.
Pulsator shaft is burnt.
Bearings of bearing ass
is defective.
8
Stop of Spin-Dry
Agitation of load (Rinsing
for 2 minutes).
Replace.
Adjust faucet
turning.
XQB100-Y1066S
REMEDY
Adjust.
Tighten.
Repair or replace
Remove.
Adjust bearing ass
Replace bearing ass
'
y
Replace.
Water supply
'
y.
'
y.
Advertisement
Table of Contents
