Advertisement
QUICK START GUIDE
Step 4 - Verify DC Input Voltage and Polarity
•
Verify that the DC Input voltage is -48VDC and matches the marked polarity using a meter.
Note: Equipment will operate properly only with proper DC Input voltage and polarity.
150028529
Step 5 - Connect DC Outputs
•
Connect DC Output and DC Output Return wires for each output.
32 DC Outputs - 8 per Module.
Module 4
1.
Strip wire 1/2"
2.
Insert wire fully into wire entry
3.
Pull wire to verify insertion
Step 6 - Connect Alarm Cable
1.
Remove alarm connector from the chassis.
2.
Connect alarm cable.
3.
Insert alarm connector into the chassis.
1. Strip wire 3/16"
2. Insert wire fully into wire entry
3. Tighten screw
Close On Alarm—COA
Open On Alarm—OOA
Common— COM
Page 3
© 2021 ABB. All rights reserved.
Positive (ground)
Negative (-48V)
DC Output Return Terminals
(-48V DC Return / Ground )
Module 3
DC Output Terminals
(-48V DC)
Module 2
Release hole (#0 Phillips or 1/8" flat screw driver)
To Remove a wire:
Push the screw driver into release hole at a downward
angle. Pull the wire out of the terminal.
Wire Entry
24 - 8 gage
Screw ( I/I6" flat screw driver
Wire entry
28 — 16 gauge
Alarm connector location — typical
150036912
Module 1
)
Advertisement
