Inserting The Batteries Into The Remote; Power Connection; Antenna Connection; Disposal Information - Telefunken TE24555S27YXD Operating Instructions Manual

Inserting the Batteries into the Remote

Remove the back cover to reveal the battery compart-
ment. Insert two size AAA batteries. Make sure the (+)
and (-) signs match (observe correct polarity). Do not
mix old and new batteries. Replace only with same or
equivalent type. Place the cover back on.
A message will be displayed on the screen when the
batteries are low and must be replaced. Note that when
the batteries are low, the performance of the remote
control may be impaired.
Batteries should not be exposed to excessive heat
such as sunshine, fire or the like.

Power Connection

IMPORTANT: The TV set is designed to operate on a
220-240V AC, 50 Hz supply. After unpacking, allow the
TV set to reach the ambient room temperature before
you connect the set to the mains. Plug the power cable
to the mains socket outlet.

Antenna Connection

Connect the aerial or cable TV plug to the AERIAL
INPUT (ANT.) socket or satellite plug to the SATELLITE
INPUT (LNB) socket located on the rear side of the TV.
Rear side of the TV
1. Satellite
2. Aerial or cable
If you want to connect a device to the TV, make
sure that both the TV and the device are turned off
before making any connection. After the connection
is done, you can turn on the units and use them.
License Notification
The terms HDMI and HDMI High-Definition Multimedia
Interface, and the HDMI Logo are trademarks or
registered trademarks of HDMI Licensing Administrator,
Inc. in the United States and other countries.
1
2
Manufactured under license from Dolby Laboratories.
Dolby, Dolby Audio and the double-D symbol are
trademarks of Dolby Laboratories.
The "CI Plus" Logo is a trademark of CI Plus LLP.

Disposal Information

[European Union]
Information for users pursuant to Art. 22 of Legislative
Decree no. 188 of 20 November 2008 "Implementation
of Directive 2006/66/EC on batteries and accumulators
and waste batteries and accumulators"
The crossed-out wheelie bin symbol on the equipment
or its packaging indicates that, at the end of their useful
life, the batteries and accumulators must be collected
separately from other waste, to allow appropriate
treatment and recycling. The final user must take
the end-of-life equipment to appropriate separate
collection facilities for electrical and electronic waste,
or return it to the retailer.
In addition to that symbol, batteries, accumulators and
button cells containing over 0.0005 percent mercury
(chemical symbol Hg), over 0.002 percent cadmium
(chemical symbol Cd) or over 0.004 percent lead
(chemical symbol Pb) are marked with the chemical
symbol of the relative metal.
Appropriate separate collection for subsequent
sending of the waste batteries and accumulators
to recycling, treatment or environmentally friendly
disposal contributes to avoiding possible effects on
the environment and health and encourages recycling-
reuse of the materials of which they are made.
Illegal dumping of batteries and accumulators by the
user results in application of the penalties indicated
in Leg. Decree no. 152/2006 and Leg. Decree no.
188/2008.
English - 5 -