Advertisement
Removing Power Supplies
b) Verify that the OUTPUT LED has turned off. If the LED is still on, return to Step 1.
c) If you are removing a DC-input power supply, ensure that the power is turned off at the power source by
turning off the power for that circuit, and then verify that the INPUT LEDs turn off.
Step 2
Detach the power and ground cables, as follows:
• For the AC-input power supply, unplug the power cables that are attached to the power supply and the
power source.
• For the DC-input power supply, open the terminal box, and use a Phillips screwdriver to remove the
power cables from their terminals. Replace the terminal box cover. Remove the power cables from the
power source.
Step 3
Remove the power supply from the chassis, as follows:
a) Press the ejector latch on the left of the power supply.
b) Pull the power supply partially out of the slot by its handle.
c) Place your other hand under the unit to support its weight.
d) Pull the power supply fully from the slot.
Caution
Catalyst 6880-X Switch Hardware Installation Guide
60
If you intend to operate the switch without installing another power supply in the empty slot, then
you must reinstall the blank cover over the empty power supply slot to ensure proper air flow in
the system and for safety reasons.
Installing and Removing Power Supplies
OL-30827-02
Advertisement
