HP RPN SCIENTIFIC WP 34S Owner's Manual page 194

c. Prepare the mount for the USB board.
Tool needed:
Procedure:
Cut away the plastic supports
of the top right screw post
and of the LCD frame in
that area. The bottom pic-
ture shows how it shall
look when you are done.
Mount the USB board.
d.
Material needed:
plastic glue, e.g. UHU.
Procedure:
Fix the board around the
screw post, left to "h.pott",
and below the terminal end. Then lay the assembly aside for drying.
e. Make the opening for the
USB plug.
Tool needed:
Procedure:
Take the grey frame and lay
it on the desk bottom up,
rubber foot pointing to you.
Then you need to extend
the opening top right.
Take measures looking at the
mounted USB board. The
pictures show how the
frame shall look when you
are done. Remember the
battery door covers the
upper part
WP 34S Owner's Manual
Small knife with a sharp thin blade.
Arbitrary
Small square file.
.
Edition 3.1 Page 194 of 211