Tune-Up - Oreck Air 16 Manual

Tune-Up

Power & Motor
Speed Control
PCO/Odor Absorber
Revitalizer, Power/Speed & Nightlight Buttons
Speed Indicators
Check Cell Lights
Night Light
1. Plug in the unit
2. Press the Power button: The fan should start
up fast then slow to Silence and the On and
Silence indicators should light up.
3. Press the Power button for Medium and High
function: The speed should increase and the
applicable indicator should light up.
4. Press the Revitalizer button: The Revitalizer
indicator should light up.
5. Press the Night Light button: The Night Light
indicator should light as well as the base lights
6. The Check Collector Cell is not normally lit.
a. Check/clean Collector Cell
7. To check the Front Cover Safety Interlock
Switch function:
a. With the unit On, grab the top
corners of the front cover and pull
back. The Front Cover should pop
loose and the unit should turn Off.
b. Remove the Front Cover.
8. Remove the Prefilter & Collector cell and install
the front cover:
a. The unit should turn back On with the
cell absent.
9. PCO Module Safety Interlock:
a. Remove the Front Cover. The PCO
Module is held in place by two small
screws (one above & one below the
brush holder).
b. Remove the screws and pull out the
PCO Module.
c. Install the front cover.
d. The unit should NOT power up with
the PCO module absent.
10. This is a good time to clean the inside of the
unit. Be sure to unplug the unit while
cleaning. When finished cleaning:
a. Install the PCO Module with two
screws.
b. Install the Collector Cell and lock in
place.
c. Install the Prefilter.
d. Install the Front Cover.
e. The unit should power up.
f. Check that all controls function as
needed.
7