NewAir AC-10100E Owner's Manual page 12

Heating Function (For AC-101OOH Only)
1. When the air conditioner is in heating mode, ambient warm air is recycled and used to heat
your immediate area. The exhaust pipe will still need to be fitted onto the unit in order
for the cold air to be removed.
2. Continuous drain is compulsory while the unit is in heat mode. Working range for heating
function is 45 to 77°F (7 ~ 25°C). If the ambient temperature is lower than this range, the unit
may not work properly.
All the functions can also be performed with the supplied remote control. The remote
control requires 2 AAA batteries to operate.
Regulating air flow direction
Please Note:
1. To prolong the life of the compressor, after turning off the unit, please wait at least 3
minutes before turning it back on.
2. The cooling system will turn off if the ambient temperature is lower than the set temperature.
However, the fan will continue operating at the set level. Once the ambient temperature
rises above the set
3. The heating system will turn off if the ambient temperature is higher than the set
temperature. The ventilation fan will continue operating at the set level. Once the ambient
temperature drops below the set temperature, heating will
4. This machine is equipped with ANTI-FROST function. When using the heating function in
low temperature the heater will occasionally stop heating in order to melt any frost that has
accumulated within the air conditioner. Normal operation will resume in a few moments.
Move the air vent directly to adjust the air flow direction
of the louvers.
temperature, cooling will resume.
A Name You Can Trust
12
resume.