Mounting the base
•
Before attaching (or removing) the base, unplug the AC cord from the AC outlet.
•
Before performing work, spread the mattress down on the base area to place the TV on. This will prevent the TV from being damaged.
first
Identify the screws that came with the TV.
Screw (×4)
2
Insert the stand into the hole in the bottom of the TV. (first)
3
Insert and tighten the screws into the holes on the back of the TV. (2)
Basic standing with the letter "R"
ATTENTION
•
To remove the base, perform the steps in reverse order.
•
Do not attach or remove the base without holding the base. Doing so may cause the sole to fall, causing serious personal injury as well as
damage to the sole.
•
The illustrations used in this manual are based on the LC-32LE280X.
•
Refer to page 11 for an illustration of the LC-40LE280X.
Soft cushion
Basic standing with the letter "L"
first
2
Antenna connection
Connect the antenna cable to the antenna port
If your outdoor antenna uses a 75-ohm
coaxial cable with a standard DIN45325 plug
(IEC 169-2), install it into the jack on the rear
of the TV.
CAREFUL
•
TO AVOID RISK OF ELECTRIC SHOCKET, DO NOT TOUCH THE PARTS OF ANY CABLE WITH THE AC WIRE
CONNECTED.
ATTENTION
•
Place the TV close to an electrical outlet and keep the AC power cord within reach.
•
The illustrations used in this manual are based on the LC-32LE280X.
•
Refer to page 11 for an illustration of the LC-40LE280X.
5
6