Pentax ist ist DL Operating Manual page 191

Problem
The focus mode is
set to \.
The focus mode is
The Autofocus set to k
does not work (Continuous mode).
The capture mode
is set to \ (Moving
Object) mode.
AE lock is not
AE lock
available when set
function does
to a (manual) mode
not operate
or p (bulb) mode
When flash mode is
set to [Auto
discharge] or [Auto
flash+Redeye
Flash does not
reduct], the flash will
discharge
not discharge when
the subject is bright.
Mode dial is set to
[Flash OFF]
The power
The camera does
zoom system
not have the power
does not
zoom function.
function
The transfer mode
USB
is set to [PictBridge].
connection with
computer does
An error occurred
not work
while sending USB
properly*
data.
USB
The transfer mode
connection with
is set to [PC] or
printer does not
[PC-F].
work properly
In rare cases, the camera may not operate correctly due to static
electricity. This can be remedied by taking the batteries out and putting
them back in again. When the mirror remains in the up position, take the
batteries out and put them back in again. Then, turn the power on. The
mirror will retract. After the procedure is done, if the camera operates
correctly, it does not require any repairs.
* Refer to p.13 of the "PENTAX PHOTO Browser 2.1/PENTAX PHOTO
Laboratory 2.1 Operating Manual" for details on connecting the camera to a PC.
Cause
Set the focus mode lever to =. (p.118)
Set the focus mode to l (Single
mode). (p.122)
Set the capture mode to setting other than
\ (Moving Object) mode. (p.47)
Use AE lock with any setting other than a
(manual) mode or p (bulb) mode.
Set flash mode to [Manual discharge] or
[Manl flash+Redeye reduct]. (p.49)
Set mode dial to any setting other than
[Flash OFF]. (p.47)
Use manual zoom. (p.48)
Set transfer mode to [PC].
Change the transfer mode to [PC-F].
Set transfer mode to [PictBridge]. (p.84)
Remedy
189
6