Machine Operating Buttons - ELNA eXcellence 710 Instruction Manual

q
q
y
w
e
r
t
t
r
e
w
7

Machine Operating Buttons

q Start/stop button
Press this button to start or stop the machine.
The machine starts running slowly for the first few
stitches, it then runs at the speed set by the speed
control slider. The machine runs slowly as long as this
button is pressed.
The button will turn red when the machine is running, and
green when it has been stopped.
Pressing and holding this button while sewing will slow
down the sewing speed and the machine will stop when
the button is released.
NOTE:
• The start/stop button cannot be used when the foot
control is connected to the machine.
• The machine will not run and the presser foot
mark y will blink if you start the presser foot in the
up position. Lower the presser foot and press the
start/stop button.
• You can select the desired start-up speed from
slow, medium or high (refer to page 26).
w Reverse button
When sewing stitch pattern 01, 04-07, 11-13, 01S,
04S-07S (MODE 1) or 37, 38 (MODE 2), the machine will
sew in reverse as long as the reverse button is pressed.
If stitch pattern 01, 04-07, 11-13, 01S, 04S-07S (MODE 1)
or 37, 38 (MODE 2) has been selected and the foot
control is not connected, the machine will start sewing in
reverse as long as the reverse button is pressed.
If you press the reverse button when sewing any other
patterns, the machine will immediately sew locking
stitches and automatically stop.
e Auto-lock button
When sewing stitch pattern 01, 04-07, 11-13, 01S,
04S-07S (MODE 1) or 37, 38 (MODE 2), the machine will
immediately sew locking stitches and automatically stop
when the auto-lock button is pressed.
When sewing all other patterns, the machine will sew to
the end of the current pattern, sew locking stitches and
stop automatically.
The machine will trim the threads automatically after
locking the stitch when the auto thread cutting option is
turned on.
r Needle up/down button
Press this button to bring the needle bar up or down.
The machine will stop with the needle in down position.
However, you can change the needle stop position in the
setting mode (refer to page 26).
t Thread cutter button
Press this button when you finish sewing to trim the
threads. The needle bar automatically rises after trimming
the threads (refer to page 30).
NOTE:
Use the thread cutter on the face cover if the thread is
#30 or thicker (refer to page 30).