Problems And Warning Signals - ELNA eXcellence 720PRO Instruction Manual

Problems and Warning Signals

If a buzzer sounds and the LCD screen shows a warning sign, follow the guidance below.
Warning Sign Cause
The foot control is out of order.
The start/stop key is pressed with the foot control
connected.
The power is turned on while depressing the foot control
The machine is turned on with the needle in the down
position.
The machine is started without lowering the presser foot.
The presser foot is raised while sewing.
The bobbin winding key is pressed when bobbin winder
stopper is at the right position.
The machine is started without lowering the buttonhole
lever.
100
Try this
Contact the service center
or the store from whom the
machine was purchased.
Disconnect the foot control.
Release the foot control.
Turn the handwheel to raise
the needle.
Lower the presser foot and
start the machine.
Shift the bobbin winder
stopper to the left for bobbin
winding.
Lower the buttonhole lever
and start the machine again.