Setting The Clock (Remote Control Only); Listening To The Ipod - Pioneer X-CM30 Operating Instructions Manual

Setting the clock (Remote control only)

TUNING/
FOLDER
In this example, the clock is set for the 24-hour (00:00)
display.
1
Press the STANDBY/ON button to turn to stand-by
mode.
2
Press and hold the CLOCK/TIMER button until "00:00"
appear.
3
Within 10 seconds, press the
the hour and then press the CLOCK/TIMER button.
Press the or button once to advance the time by
1 hour. Hold it down to advance continuously.
4
Press the or button to adjust the minutes and
then press the CLOCK/TIMER button. Press the
button once to advance the time by 1 minute. Hold
it down to advance continuously.
To confirm the time display:
[When the unit is in the stand-by mode]
Press the CLOCK/TIMER button. The time display will
appear for about 5 seconds.
[When the power is on]
Press the CLOCK/TIMER button. The time display will
appear for about 5 seconds.
Note:
The "00:00" will appear when the AC power supply is
restored after a power failure or unplugging the unit.
Readjust the clock as follows.
To readjust the clock:
Perform "Setting the clock" from step 1.
or button to adjust
or
En-9

Listening to the iPod

Supported iPod models:
l iPod nano
l iPod classic
l iPod touch
th
l iPod (5 generation and above)
Notes:
Once the iPod is connected to the unit it will begin
l
charging.
The iPod unit cannot be charged whilst the main unit is
l
in USB mode.
n iPod adaptor connection
The marking shows
which iPod fits
iPod
Adaptor iPod Description
No.
A 5G iPod (with video)
iPod classic
iPod touch
iPod touch (2nd Gen.)
iPod nano (3rd Gen.)
B iPod nano
iPod nano (2nd Gen.)
iPod nano (4th Gen.)
E
5G iPod with video
iPod classic
Notes:
l If you have an iPod that does not have an iPod 30 Pin
connector, you can use an audio cable to connect it to
the AUDIO/LINE IN socket.
l iPhone is not supported by this system.
A
Capacity
30GB
80GB & 120GB
8GB & 16GB
8GB, 16GB &
32GB
4GB & 8GB
2GB & 4GB
2GB, 4GB & 8GB
8GB & 16GB
60GB & 80GB
160GB