Manual Trigger Mode; When In Manual Trigger Mode, The Scanner Scans Until A Bar Code Is Read, Or Until The Trigger Is Released; Led Illumination - Manual Trigger; Character Activation Mode - Honeywell Virtuos 1D User Manual

Manual Trigger Mode

When in manual trigger mode, the scanner scans until a bar code is read, or until the trigger is released.

LED Illumination - Manual Trigger

If you wish to set the illumination LED brightness, scan one of the bar codes below. This sets the LED illumination for the
scan engine when the trigger is pressed. Default = High.
Note: The LEDs are like a flash on a camera. The lower the ambient light in the room, the brighter the LEDs need to be so
the scan engine can "see" the bar codes.
Low

Character Activation Mode

You may use a character sent from the host to trigger the scanner to begin scanning. When the activation character is received,
the scanner continues scanning until either the
(see Deactivation Character
tion, then use Activation Character (following) to select the character you will send from the host to start scanning. Default = Off.
* Off

Activation Character

This sets the character used to trigger scanning when using Character Activation Mode. On the
(Code Page 1252), page A-3, find the hex value that represents the character you want to use to trigger scanning. Scan the
following bar code, then use the
acter. Scan Save to finish. Default = 12 [DC2].
Manual Trigger - Normal
Character Activation Timeout
on page 3-7), or a bar code is transmitted. Scan the following On bar code to use character activa-
Programming Chart
Activation Character
(page 3-6), the deactivation character is received
to read the alphanumeric combination that represents that ASCII char-
* High
On
ASCII Conversion Chart
3 - 5