Sanyo ICR-XPS01M Instruction Manual page 60

• In the range where the LED light does not
come on quickly, try as much as possible to
increase the recording level (level meters
extending to the right) by tapping
you can collect more sound.
• If the LED light flashes quickly, tap
slightly lower the recording level until the LED
light goes off.
• If the LED still lights after you have dropped
the recording level to 1, change the "MIC
SENS." setting to "LOW".
If the level meter does not reach an
appropriate recording level after you have
increased the recording level to 30, change
the "MIC SENS." setting to "HIGH".
MIC SENS. (page 133)
• An appropriate recording level is achieved
when the level meters do not extend to the far
right and the LED light does not flash quickly
even after you increase the sound you want to
record to its maximum.
• Generally speaking, we recommend that you
adjust the level to around -6. If the LED light
flashes quickly, this indicates the input level is
too high and distorted sound will be recorded.
* If the LED light menu is set to "OFF", the LED
light does not come on.
LED SETTING (page 150)
60
so that
to
LED light LED light
If the recording If the recording
level is too low level is too low
If the recording If the recording
level is too high level is too high
Appropriate Appropriate
recording level recording level