Toshiba Satellite A100 User Manual page 206

User's Manual
&T0 Abort. Stops any test in progress.
&T1 Local analog loop. This test verifies modem operation, as well
as the connection between the modem and computer. Any data
entered at the local DTE is modulated, then demodulated, and
returned to the local DTE. To work properly, the modem must
be off-line.
Result Codes:
OK
CONNECT
ERROR
&VDisplay Current Configuration
This command displays the current configuration of the modem. If non-
volatile memory is supported the stored profiles are displayed as well.
&V
View profiles.
&WStore current configuration
Saves the current (active) configuration (profile), including S-Registers.
The current configuration comprises a list of storable parameters illus-
trated in the &V command. These settings are restored to the active con-
figuration upon receiving a Zn command or at power up. Refer to the
&V command.
&W Stores the current configuration.
&Zn=x Store telephone number
This command is used to store up to four dialing strings in the modem's
nonvolatile memory for later dialing. The format for the command is
&Zn="stored number" where n is the location 0-3 to which the number
should be written. The dial string may contain up to 34 characters. The
ATDS=n command dials using the string stored in location n.
Result codes:
n=0, 1, 2, 3
OK
ERROR Otherwise
C-10
n=0
n=1
Otherwise