Panasonic DMR-HST270 Operating Instructions Manual page 63

You cannot play contents properly from DLNA
compatible equipment on the network.
• There may be some video that cannot be played
back on DLNA compatible equipment
depending on the equipment.
• Following programmes may not be played back:
- A programme with access restriction
- A programme with incompatible format
• Playback via DLNA compatible equipment may
not be performed when this unit is in the
following conditions:
- While simultaneously performing Copy (Keep
Picture Quality) and recording
- While displaying the Basic Settings menu
- While executing functions using a network,
such as Network Service
• If the DLNA compatible equipment is not
capable of outputting HE-AAC audio format,
etc., sound may not be played back.
When using Wireless LAN connection, video
from the DLNA Certified media server is not
played back or video frames are dropped
during playback.
• Use 802.11n (2.4 GHz or 5 GHz) Wireless router.
Simultaneous use with a microwave, cordless
telephone etc. at 2.4 GHz may result in
connection interruptions or other problems.
• On the "Wireless Settings" screen (
continuous lighting of at least four "Reception"
indicators is the target for a stable connection. If
three or fewer indicators are lit or the connection is
being interrupted, change the position or angle of
your Wireless router. If there is no improvement,
connect to a wired network and perform the "Easy
Network Setting" ( 11, 56) again.
Reset
To return all the settings to the factory preset
Perform "Shipping Condition" or "Default
Settings". ( 59)
Messages on the front panel display
The following messages or service numbers appear on the
front panel display when something unusual is detected.
CONV
The picture quality of the selected programme stored in the
USB HDD is being changed.
Do not disconnect the USB HDD from this unit.
GUIDE
TV Guide data is being downloaded.
PLEASE WAIT
• Displayed when the unit is started and is switched to
standby mode.
• There was a power failure or the AC plug was disconnected
while the unit was on. The unit is carrying out its recovery
process. Wait until the message disappears.
PROG FULL
There are already 32 timer programmes. Delete unnecessary
timer programmes. (
REMOVE
The USB device is drawing too much power. Remove the
USB device.
SET (" " stands for a number.)
The remote control and main unit are using different codes.
Change the code on the remote control. (
START
Update of the software (firmware) is started. You cannot
operate the unit until the update is complete. (
SW-DL
Software (firmware) is downloading.
Download will stop when the unit is turned on, or the timer
recording starts. (
When "FINISH" is displayed, update of the software
(firmware) has completed.
UNSUPPORT
The media is not supported.
UPD / (" " stands for a number.)
The software (firmware) is being updated. You cannot
56), the
operate the unit until the update is complete. (
U50
An error has occurred in the antenna's power supply. Check
to see if the antenna's cable core and braided wire shield are
in contact with each other.
U59
The unit is hot. The unit switches to standby for safety reasons.
Wait for about 30 minutes until the message disappears.
Install or place this unit with good ventilation.
U61
A malfunction has occurred. The unit is trying to restore to the
normal operation. Once the message disappears you can use
the unit again. If it remains displayed, consult the dealer.
U76
HDMI cannot be output because it is connected to a model
that does not support copyright protection.
U99
The unit fails to operate properly. Press [Í/I] on the main unit
to switch the unit to standby mode. Now press [Í/I] on the
main unit again to turn the unit on.
X HOLD
The HOLD function is activated. (
21)
60)
50)
51)
TQBS0165
50)
50)
63