Shutting Down The Projector - BenQ LW550 User Manual

Once detected, the selected source information will appear at the corner of the screen for
seconds. If there is multiple equipment connected to the projector, repeat steps 1-2 to
search for another signal.
• The brightness level of the projected image will change accordingly when you switch between different
input signals.
• For best display picture results, you should select and use an input signal which outputs at the
projector's native resolution. Any other resolutions will be scaled by the projector depending upon the
"aspect ratio" setting, which may cause some image distortion or loss of picture clarity. See
Ratio on page

Shutting down the projector

1. Press on the projector or
control and a confirmation message will appear
prompting you. If you don't respond in a few
seconds, the message will disappear.
2. Press or
flashes orange, the projection light source shuts
down, and the fans will continue to run for
approximately 2 seconds to cool down the projector.
3. Once the cooling process finishes, the power
indicator becomes a steady orange and fans stop. Disconnect the power cord from the
power outlet.
To protect the light source, the projector will not respond to any commands during the cooling process.
24 Operation
29.
on the remote
a second time. The power indicator
Aspect