Installing The Transmitter - Husqvarna Automover 536576003 Manual

Installing the transmitter

1. Clean any dirt and debris from the chassis interior.
2. Peel the paper from the transmitter mounting bracket adhesive strip (G) and apply it to the
planned transmitter mounting location (X).
3. Apply the transmitter mounting bracket (H) onto the adhesive strip. Press firmly into place.
4. Install the transmitter circuit board (J) onto the transmitter mounting bracket. The side of the
transmitter circuit board into which the wiring assembly connects must face forward relative to
the normal motion of the mower.
5. Connect one end of the wiring assembly into an available "AUX" port on the motor control circuit
board (Z).
Note: Some models have multiple options for connecting the wiring assembly. All are acceptable,
but the wiring assembly MUST be connected to the motor control circuit board or application circuit
board. Do not connect the wiring assembly to the COM board.
6. Pass the wiring assembly through the cable holders (Y).
a
CAUTION: Make sure the wiring assembly is not pinched.
7. Connect the other end of the wiring assembly to the transmitter circuit board.
TRANSMITTER CONNECTION DIAGRAM
J
H
G
415X
8